Timer Actual Value | Toshiba MK6017MAP guide

360014937

WORD 89: The time period for Security Erase Unit command completion shall be set.

	TIMER	ACTUAL VALUE
	0	Not specified
	1-254	( Timer ×2 ) minuites
	255	> 508 minuites
WORD 90:	Reserved
WORD 91: Current Advanced Power Management setting
bit 15-8	Reserved
bit 7-0	Current Advanced Power Management setting set by Set Features Command.

The default value for this WORD is0080h.

WORD 92: Master Password Revision Code

the value of the Master Password Revision Code set when the Master Password was last change. Valid values are 0001h through FFFEh. A value of 0000h or FFFFh indicates that the Master Password Revision is not supported.

WORD 93: Hardware configuration test results

bit 15	0	(Fixed)
bit 14	1	(Fixed)
bit 13	1=device detected CBLID- above VIH
bit12-8	0=device detected CBLID- below VIL
bit12-8	Device 1 hardware reset result. Device 0 shall clear these bits to zero.
	Device 1 shall set these bits as follows :
		12	Reserved.
		11	0=Device 1 did not assert PDIAG-.
			1=Device 1 asserted PDIAG-.
		10-9	These bits indicate how Device 1 determined the device number:
			00=Reserved.
			01=a jumper was used.
			10=the CSEL signal was used.
			11=some other method was used or the method is unknown.
		8	1	(Fixed)
bit 7-0	Device 0 hardware reset result. Device 1 shall clear these bit to zero.
	Device 0 shall set these bills as follows:
		7	Reserved.
		6	0=Device 0 does not respond when Device 1 is selected.
			1=Device 0 responds when Device 1 is selected.
		5	0=Device 0 did not detect the assertion of DASP-.
			1=Device 0 detected the assertion of DASP-.
		4	0=Device 0 did not detect the assertion of PDIAG-.
			1=Device 0 detected the assertion of PDIAG-.
		3	0=Device 0 failed diagnostics.
			1=Device 0 passed diagnostics.
		2-1	These bits indicate how Device 0 determined the device number:
			00=Reserved.
			01=a jumper was used.
			10=the CSEL signa was used.
			11=some other method was used or the method is unknown.
		0	1	(Fixed)

Copyright ©2000 Toshiba corporation. All rights reserved.

- 584 -

Image 84

Toshiba MK6017MAP manual Timer Actual Value

Contents

Toshiba Contents REVRevised STGE.PER Ｓａｆｅｔｙ Usage Restrictions Safety Copyright 2000 Toshiba corporation. All rights reserved 506 Table of Contents Security SET Password Protocol Table of Figures Scope Copyright 2000 Toshiba corporation. All rights reserved 512 KEY Features Basic Specification Performance Power Consumption Power SequenceSupply Voltage Energy Consumption Efficiency Dimension WeightDrive Orientation Mounting Instructions Installation Screwing MK6017MAP Dimensions MK6017MAP Mounting Recommendation Temperature and Humidity TemperatureVibration Shock Acoustics （Sound Power ） Safety StandardsAltitude Error Rate Preventive Maintenance PMMean Time to Failure Mttf Product Life Load/Unload Interface Connector CablingCable Electrical specification DC input/output Characteristics 10.2.2.1 InputCable length and capacitance Output Interface connector ATA interface connector Pin Assignment Pdiag ／-CBLIDDasp Ground Ground Reserved Signal Treatment Dasp Signal Description Series resistance Copyright 2000 Toshiba corporation. All rights reserved 532 Host Interface Timing Program I/O Write Timing Program I/O Read Timing ATA-2 Specifications Single Word DMA Write Timing ATA-2 Specification Single Word DMA Read Timing ATA/ATAPI-5 Specifications Multiword DMA Write Timing Multiword DMA Read Timing Ultra DMA Timing Hdmardy Sustained Ultra DMA data in burst Device terminating an Ultra DMA data in burst CRC Host terminating an Ultra DMA data in burst Initiating an Ultra DMA data out burst Ddmardy Sustained Ultra DMA data out burst Host terminating an Ultra DMA data out burst Device terminating an Ultra DMA data out burst ATA/ATAPI specifications Reset Timing Grounding Address Decoding 1 Register map Register Description Security commands Error RegisterOperational Mode Diagnostic Mode Smart commandDisk Access command Initialize Device Parameters command Smart commands Sector Number RegisterCylinder Low Registers Cylinder High Registers Device/Head Register DEV HS3 HS2 HS1 HS0 Status Register BSY Drdy DSC3 DRQ Corr IDX ERR Command Register Command Code Alternate Status Register Device Control RegisterDevice Address register4 Srst IEN Command Descriptions Nop 00h Recalibrate5 1xhFlush Cache E7h Read Sector 20h/21h Read Long6 22h/23hWrite Sector 30h/31h Write Long7 32h/33h Read Verify 40hWrite Verify8 3Ch Format Track 50h Execute Diagnostics 90h Seek 7xhToshiba Specific Initialize Device Parameters 91h Read Multiple C4h Write Multiple C5h Set Multiple Mode C6h Read DMA C8h/C9h Write DMA CAh/CBh Power Control Exh Stand-by Immediate E0/94Idle Immediate E1/95 SC=X Check Power Mode E5/98 Stand-by E2/96Idle E3/97 Sleep E6/99 Read Buffer E4h Write Buffer E8h Identify Device ECh Word Description Hex 360014937 2 Identify Information 360014937 3 Identify Information 360014937 4 Identify Information =ATA Toshiba MK6017MAP MK6017MAP Copyright 2000 Toshiba corporation. All rights reserved 581 Copyright 2000 Toshiba corporation. All rights reserved 582 Copyright 2000 Toshiba corporation. All rights reserved 583 Timer Actual Value Copyright 2000 Toshiba corporation. All rights reserved 585 Set Max Address F9h Read Native Max Address F8h Set Features EFh Features FT register defines following selections Security SET Password F1h Security Set Password information Security Unlock F2h Security Erase Prepare F3h Security Erase Unit F4h Security Freeze Lock F5h Security Disable Password F6h Smart Function Set 10.8.33.1 Smart Read Attribute values Attribute Name Value Definition Copyright 2000 Toshiba corporation. All rights reserved 596 10.8.33.2 Smart Read Attribute thresholds Smart Enable Disable Attribute Autosave 10.8.33.4 Smart Save Attribute Values Off-line mode 10.8.33.5 Smart Execute Off-line Immediate Captive mode Command Code Register Setting Normal Completion10.8.33.6 Register Command data structure Error data structure Self-test log sector Self-test index 10.8.33.7 Smart Write Log Sector Smart Enable Operations 10.8.33.9 Smart Disable Operations Smart Enable/Disable Automatic Off-line Smart Return Status Security mode default setting Initial setting of the user password Security mode operation from power-on UnlockUnit Password lost Command Table Smart function default setting AttributesAttributes values Adaptive Power Mode Control Low Power IdlePerformance Idle Active Idle Reset Register Power on Hardware Reset Software Reset Master/Slave Configuration LOWHigh Cache Memory Automatic Write ReallocationCache Operations Protocol PIO data in commands Commands for this class are PIO data out commands PIO data out protocol Non-data commands Non-data protocol DMA data transfer commands Ultra DMA Copyright 2000 Toshiba corporation. All rights reserved 624 = DD0 XOR CRCOUT15 = DD1 XOR CRCOUT14= DD2 XOR CRCOUT13 = DD3 XOR CRCOUT12 Function and Intervals Timeout Other timings