Toshiba MK6017MAP manual Security Erase Unit F4h, Security Freeze Lock F5h

360014937

10.8.30 SECURITY ERASE UNIT (F4h)

COMMAND CODE			1 1 1 1 0 1 0 0	REGISTER
	REGISTER SETTING			NORMAL COMPLETION
DR		DRIVE No.		no change
CY				no change
HD				no change
SN				no change
SC				no change
FT				no change

This command must be issued immediately after the SECURITY ERASE PREPARE command.

This command requests to transfer a sector of data from the host including the data specified in the following table. If the password does not match, the drive rejects the command with an Aborted command error.

		Security Erase Unit Information
Word		Content
0	Control word
	Bit 15-1	Reserved
	Bit 0	Identifier 0=compare user password
		1=compare master password
1-16	Password (32 bytes)
17-255	Reserved

The SECURITY ERASE UNIT command erases all user data. The SECURITY ERASE PREPARE command must be completed immediately prior to the SECURITY ERASE UNIT command, otherwise, the SECURITY ERASE UNIT command shall be aborted..

This command disables the drive lock function, however, the master password is still stored internally within the drive and may be reactivated later when a new user password is set.

10.8.31 SECURITY FREEZE LOCK (F5h)

COMMAND CODE			1 1 1 1 0 1 0 1	REGISTER
	REGISTER SETTING			NORMAL COMPLETION
DR		DRIVE No.		no change
CY				no change
HD				no change
SN				no change
SC				no change
FT				no change

The SECURITY FREEZE LOCK allows the drive to enter frozen mode. After the completion of this command, any other commands that update the drive lock functions are rejected. The drive recovers from the frozen mode by power-on reset or hard reset. If SECURITY FREEZE LOCK is issued when the drive is in frozen mode, the drive executes the command and remains in frozen mode.

Following commands are rejected when the drive is in SECURITY FREEZE LOCK mode.

•SECURITY SET PASSWORD

•SECURITY UNLOCK

•SECURITY DISABLE PASSWORD

•SECURITY ERASE UNIT

Copyright ©2000 Toshiba corporation. All rights reserved.

- 590 -