Toshiba MK6017MAP | Toshiba guide

bit 12 bit 11 bit 10 bit 9 bit 8 bit 7- 0

360014937

WORD 23-26: Firmware revision ( 8 ASCII characters )

WORD 27-46: Model name (40 ASCII characters)

Drive Type

MK6017MAP	TOSHIBA MK6017MAP_..._
－	－

－	－

	“_” indicates ASCII space code.

WORD 47:

bit 15 - 8 shall be set to 80h

bit 7 - 0 Maximum number of sectors that can be transferred per interrupt on READ/WRITE MULTIPLE commands.

The default value for this WORD is 8010h.

WORD 48: Reserved

WORD 49: Capabilities

bit 15-14 0=Reserved

bit 13 1=Standby timer value shall be as specified in ATA-/ ATAPI-5 specification 0=Standby timer value are vendor specific

Reserved (For advanced PIO mode support) 1=IORDY is supported.

1=IORDY function can be disabled. shall be set to 1.

shall be set to 1. Reserved

The value for this WORD is 0F00h.

WORD 50: Capabilities

bit 15	0	(Fixed)
bit 14	1	(Fixed)
bit 13-1	Reserved
bit 0	1=device has a minimum Standby timer value that is device specific.
Standby timer value is set to 5 minutes or more. The value for this WORD is 4001h.
WORD 51: PIO data transfer cycle timing mode
bit 15- 8	PIO data transfer cycle timing mode
bit 7- 0	Reserved

The value returned in Bits 15-8 should fall into one of the mode 0 through mode.

Note: For backwards compatibility with BIOS written before Word 64 was defined for advanced modes, a device reports in Word 51 the highest original PIO mode (i.e. PIO mode 0, 1, or 2) it can support.

The value for this WORD is 0200h.

WORD 52: Reserved
WORD 53:
bit15- 3	Reserved
bit 2	1= the fields reported in word	88 is valid
bit 1	1= the fields reported in words 64～70 are valid
bit 0	1= the fields reported in words 54～58 are valid

If the number of heads and sectors exceed the drive parameter, bit 0 and related WORD 54-58 shall be cleared to 0. The default value for this WORD is 0007h.

Copyright © 2000 Toshiba corporation. All rights reserved.

- 579 -

Image 79

Toshiba manual Toshiba MK6017MAP

Contents

Toshiba STGE.PER ContentsREV Revised Ｓａｆｅｔｙ Usage Restrictions Safety Copyright 2000 Toshiba corporation. All rights reserved 506 Table of Contents Security SET Password Protocol Table of Figures Scope Copyright 2000 Toshiba corporation. All rights reserved 512 KEY Features Basic Specification Performance Energy Consumption Efficiency Power ConsumptionPower Sequence Supply Voltage Mounting Instructions DimensionWeight Drive Orientation Screwing Installation MK6017MAP Dimensions MK6017MAP Mounting Recommendation Shock Temperature and HumidityTemperature Vibration Safety Standards Acoustics （Sound Power ）Altitude Product Life Error RatePreventive Maintenance PM Mean Time to Failure Mttf Load/Unload Cabling Interface ConnectorCable Output Electrical specificationDC input/output Characteristics 10.2.2.1 Input Cable length and capacitance ATA interface connector Interface connector Ground Reserved Pin AssignmentPdiag ／-CBLID Dasp Ground Dasp Signal Treatment Series resistance Signal Description Copyright 2000 Toshiba corporation. All rights reserved 532 Program I/O Write Timing Host Interface Timing Program I/O Read Timing Single Word DMA Write Timing ATA-2 Specifications Single Word DMA Read Timing ATA-2 Specification Multiword DMA Write Timing ATA/ATAPI-5 Specifications Multiword DMA Read Timing Hdmardy Ultra DMA Timing Sustained Ultra DMA data in burst CRC Device terminating an Ultra DMA data in burst Host terminating an Ultra DMA data in burst Ddmardy Initiating an Ultra DMA data out burst Sustained Ultra DMA data out burst Host terminating an Ultra DMA data out burst Device terminating an Ultra DMA data out burst ATA/ATAPI specifications Grounding Reset Timing 1 Register map Address Decoding Register Description Error Register Security commandsOperational Mode Initialize Device Parameters command Diagnostic ModeSmart command Disk Access command Cylinder High Registers Smart commandsSector Number Register Cylinder Low Registers DEV HS3 HS2 HS1 HS0 Device/Head Register BSY Drdy DSC3 DRQ Corr IDX ERR Status Register Command Register Command Code Srst IEN Alternate Status RegisterDevice Control Register Device Address register4 Command Descriptions Recalibrate5 1xh Nop 00hFlush Cache E7h Read Long6 22h/23h Read Sector 20h/21hWrite Sector 30h/31h Read Verify 40h Write Long7 32h/33hWrite Verify8 3Ch Format Track 50h Seek 7xh Execute Diagnostics 90hToshiba Specific Initialize Device Parameters 91h Read Multiple C4h Write Multiple C5h Read DMA C8h/C9h Set Multiple Mode C6h Write DMA CAh/CBh SC=X Power Control ExhStand-by Immediate E0/94 Idle Immediate E1/95 Sleep E6/99 Check Power Mode E5/98Stand-by E2/96 Idle E3/97 Write Buffer E8h Read Buffer E4h Identify Device ECh Hex Word Description 360014937 2 Identify Information 360014937 3 Identify Information 360014937 4 Identify Information =ATA Toshiba MK6017MAP MK6017MAP Copyright 2000 Toshiba corporation. All rights reserved 581 Copyright 2000 Toshiba corporation. All rights reserved 582 Copyright 2000 Toshiba corporation. All rights reserved 583 Timer Actual Value Copyright 2000 Toshiba corporation. All rights reserved 585 Read Native Max Address F8h Set Max Address F9h Features FT register defines following selections Set Features EFh Security Set Password information Security SET Password F1h Security Erase Prepare F3h Security Unlock F2h Security Freeze Lock F5h Security Erase Unit F4h F6h Security Disable Password Smart Function Set Smart Read Attribute values 10.8.33.1 Attribute Name Value Definition Copyright 2000 Toshiba corporation. All rights reserved 596 Smart Read Attribute thresholds 10.8.33.2 10.8.33.4 Smart Save Attribute Values Smart Enable Disable Attribute Autosave 10.8.33.5 Smart Execute Off-line Immediate Off-line mode Captive mode Register Command CodeRegister Setting Normal Completion 10.8.33.6 Command data structure Error data structure Self-test log sector Self-test index 10.8.33.7 Smart Write Log Sector 10.8.33.9 Smart Disable Operations Smart Enable Operations Smart Return Status Smart Enable/Disable Automatic Off-line Initial setting of the user password Security mode default setting Unlock Security mode operation from power-onUnit Password lost Command Table Attributes Smart function default settingAttributes values Active Idle Adaptive Power Mode ControlLow Power Idle Performance Idle Register Power on Hardware Reset Software Reset Reset LOW Master/Slave ConfigurationHigh Automatic Write Reallocation Cache MemoryCache Operations Protocol Commands for this class are PIO data in commands PIO data out protocol PIO data out commands Non-data protocol Non-data commands DMA data transfer commands Ultra DMA Copyright 2000 Toshiba corporation. All rights reserved 624 = DD3 XOR CRCOUT12 = DD0 XOR CRCOUT15= DD1 XOR CRCOUT14 = DD2 XOR CRCOUT13 Other timings Function and Intervals Timeout