Word Description, Hex | Toshiba MK6017MAP guide

360014937

Table 10.8-1 Identify Information

WORD				DESCRIPTION	Hex.
0	General configuration				0040
	15		0=ATA device
	14-8		Reserved
	7		1=Removable cartridge device
	6		1=Fixed device
	5-3		Reserved
	2		Response incomplete
	1-0		Reserved
1	Number of default logical cylinders				[1*]
2	Specific configuration				C837
3	Number of default logical heads				[2*]
4	Reserved				0000
5	Reserved				0000
6	Number of default logical sectors h logical track				[3*]
7-9	Reserved
10-19	Serial Number (20 ASCII characters)
20	Reserved				0000
21	Reserved				0000
22	Number of vendor specific ECC bytes transferred on READ/WRITE LONG				002E
	commands
23-26	Firmware Revision (8 ASCII characters)
27-46	Controller model # (40 ASCII characters)
47	15-8	80h			8010
	7-0 00H = READ/WRITE MULTIPLE command not implemented
			01H- FFH = Maximum number of sectors that can be transferred per
		interrupt		on READ/WRITE MULTIPLE commands
48	Reserved				0000
49	Capabilities				0F00
	15-14		Reserved
		13 1=Standby timer values as specified in ATA/ATAPI-5 specification are
			supported
			0=Standby timer values are vendor specific
		12	Reserved
		11	1=IOCHRDY supported
		10 1=IOCHRDY can be disabled
		9	1
		8	1
	7-0		Reserved
50	Capabilities				4001
		15	0 (Fixed)
		14	1 (Fixed)
	13-1		Reserved
		0 1= a device specific Standby timer value minimum.
51	15-8 PIO data transfer cycle timing mode				0200
	7-0	Reserved
52	Reserved				0000
53	15-3	Reserved			0007
		2 1=the fields reported word 88 are valid
			0=the fields reported word 88 are not valid
		1 1=the fields reported words 64-70 are valid
			0=the fields reported words 64-70 are not valid
		0 1=the fields reported words 54-58 are valid
			0=the fields reported words 54-58 are not valid

54	Number of current cylinders				XXXX
55	Number of current heads				XXXX
56	Number of current sectors per track				XXXX

Copyright ©2000 Toshiba corporation. All rights reserved.

- 574 -

Image 74

Toshiba MK6017MAP manual Word Description, Hex

Contents

Toshiba Revised ContentsREV STGE.PER Ｓａｆｅｔｙ Usage Restrictions Safety Copyright 2000 Toshiba corporation. All rights reserved 506 Table of Contents Security SET Password Protocol Table of Figures Scope Copyright 2000 Toshiba corporation. All rights reserved 512 KEY Features Basic Specification Performance Supply Voltage Power ConsumptionPower Sequence Energy Consumption Efficiency Drive Orientation DimensionWeight Mounting Instructions Installation Screwing MK6017MAP Dimensions MK6017MAP Mounting Recommendation Vibration Temperature and HumidityTemperature Shock Altitude Acoustics （Sound Power ）Safety Standards Mean Time to Failure Mttf Error RatePreventive Maintenance PM Product Life Load/Unload Cable Interface ConnectorCabling Cable length and capacitance Electrical specificationDC input/output Characteristics 10.2.2.1 Input Output Interface connector ATA interface connector Dasp Ground Pin AssignmentPdiag ／-CBLID Ground Reserved Signal Treatment Dasp Signal Description Series resistance Copyright 2000 Toshiba corporation. All rights reserved 532 Host Interface Timing Program I/O Write Timing Program I/O Read Timing ATA-2 Specifications Single Word DMA Write Timing ATA-2 Specification Single Word DMA Read Timing ATA/ATAPI-5 Specifications Multiword DMA Write Timing Multiword DMA Read Timing Ultra DMA Timing Hdmardy Sustained Ultra DMA data in burst Device terminating an Ultra DMA data in burst CRC Host terminating an Ultra DMA data in burst Initiating an Ultra DMA data out burst Ddmardy Sustained Ultra DMA data out burst Host terminating an Ultra DMA data out burst Device terminating an Ultra DMA data out burst ATA/ATAPI specifications Reset Timing Grounding Address Decoding 1 Register map Register Description Operational Mode Security commandsError Register Disk Access command Diagnostic ModeSmart command Initialize Device Parameters command Cylinder Low Registers Smart commandsSector Number Register Cylinder High Registers Device/Head Register DEV HS3 HS2 HS1 HS0 Status Register BSY Drdy DSC3 DRQ Corr IDX ERR Command Register Command Code Device Address register4 Alternate Status RegisterDevice Control Register Srst IEN Command Descriptions Flush Cache E7h Nop 00hRecalibrate5 1xh Write Sector 30h/31h Read Sector 20h/21hRead Long6 22h/23h Write Verify8 3Ch Write Long7 32h/33hRead Verify 40h Format Track 50h Toshiba Specific Execute Diagnostics 90hSeek 7xh Initialize Device Parameters 91h Read Multiple C4h Write Multiple C5h Set Multiple Mode C6h Read DMA C8h/C9h Write DMA CAh/CBh Idle Immediate E1/95 Power Control ExhStand-by Immediate E0/94 SC=X Idle E3/97 Check Power Mode E5/98Stand-by E2/96 Sleep E6/99 Read Buffer E4h Write Buffer E8h Identify Device ECh Word Description Hex 360014937 2 Identify Information 360014937 3 Identify Information 360014937 4 Identify Information =ATA Toshiba MK6017MAP MK6017MAP Copyright 2000 Toshiba corporation. All rights reserved 581 Copyright 2000 Toshiba corporation. All rights reserved 582 Copyright 2000 Toshiba corporation. All rights reserved 583 Timer Actual Value Copyright 2000 Toshiba corporation. All rights reserved 585 Set Max Address F9h Read Native Max Address F8h Set Features EFh Features FT register defines following selections Security SET Password F1h Security Set Password information Security Unlock F2h Security Erase Prepare F3h Security Erase Unit F4h Security Freeze Lock F5h Security Disable Password F6h Smart Function Set 10.8.33.1 Smart Read Attribute values Attribute Name Value Definition Copyright 2000 Toshiba corporation. All rights reserved 596 10.8.33.2 Smart Read Attribute thresholds Smart Enable Disable Attribute Autosave 10.8.33.4 Smart Save Attribute Values Off-line mode 10.8.33.5 Smart Execute Off-line Immediate Captive mode 10.8.33.6 Command CodeRegister Setting Normal Completion Register Command data structure Error data structure Self-test log sector Self-test index 10.8.33.7 Smart Write Log Sector Smart Enable Operations 10.8.33.9 Smart Disable Operations Smart Enable/Disable Automatic Off-line Smart Return Status Security mode default setting Initial setting of the user password Unit Security mode operation from power-onUnlock Password lost Command Table Attributes values Smart function default settingAttributes Performance Idle Adaptive Power Mode ControlLow Power Idle Active Idle Reset Register Power on Hardware Reset Software Reset High Master/Slave ConfigurationLOW Cache Operations Cache MemoryAutomatic Write Reallocation Protocol PIO data in commands Commands for this class are PIO data out commands PIO data out protocol Non-data commands Non-data protocol DMA data transfer commands Ultra DMA Copyright 2000 Toshiba corporation. All rights reserved 624 = DD2 XOR CRCOUT13 = DD0 XOR CRCOUT15= DD1 XOR CRCOUT14 = DD3 XOR CRCOUT12 Function and Intervals Timeout Other timings