Chapter 1

Using the CLI

Avaya C460 Sessions

You can use sessions to switch between C460 Supervisor modules or to switch between Layer 2 and Layer 3 commands in the C460 CLI.

To switch between C460 modules use the command: session [<mod_num>] <mode>.

The <mod_num> is the number of the module in the chassis, counting from the top down. The <mode> can be either switch or router. When Module Number is not specified, the command switches between the modes in the local module. Use switch mode to configure layer 2 commands. Use router mode to configure routing commands.

Example:

To configure router parameters in the module that you are currently logged into, type the following command:

session router.

When you use the session command the security level stays the same.

8

Avaya C460 Reference Guide

Page 20
Image 20
Avaya manual Avaya C460 Sessions, Session router