Chapter 2 Avaya C460 CLI Commands

seconds

Time interval in seconds — 0-65535

Example:

C460-1(super)#set port dot1x quiet-period 1/2 5000

set port duplex

User level: read-write, admin.

Use the set port duplex command to configure the duplex type of an Ethernet or Fast Ethernet port or range of ports.You can configure Ethernet and Fast Ethernet interfaces to either full duplex or half duplex.

The duplex status of a port in auto-negotiation mode is determined by auto- negotiation. An error message is generated if you attempt to set the transmission type of auto negotiation Fast Ethernet ports to half- or full-duplex mode.

The syntax for this command is:

set port duplex <module>/<port> [value]

module

Number of the module (3-6). If you do not specify a number,

 

the ports on all the modules are shown.

port

Number of the port on the module. If you do not specify a

 

number, all the ports on the module are shown.

 

You can also specify a range of ports separated by a dash, for

 

example, 4/5-13 for ports 5 to 13 on module 4.

value

• full – set full-duplex transmission

 

• half – set half-duplex transmission

Example:

To set port 1 on module 4 to full duplex:

C460-1#set port duplex 4/1 full

Port 4/1 set to full-duplex.

set port edge admin state

User level: read-write, admin.

Use the set port edge admin state command to set the port as an RSTP edge-port or non-edge-port.

106

Avaya C460 Reference Guide

Page 118
Image 118
Avaya manual C460-1super#set port dot1x quiet-period 1/2, Set port duplex, C460-1#set port duplex 4/1 full