Avaya C460 manual RIP update timer in seconds minimum =

Chapter 2 Avaya C460 CLI Commands

You can only access these commands in the Router-RIP context.

Type router rip at the command prompt to enter the Router-RIP context if necessary.

Use the timers basic command to configure the route timer.

Use the no timers basic command to restore the timers to their default values.

Example:

Router-N(configure router:rip)# timers basic 30 180

The syntax for this command is:

timers basic <update><invalid>

update	RIP update timer in seconds (minimum = 30;
	default = 30)
invalid	RIP invalid route timer in seconds (minimum =30;
	default = 180)

The Invalid Route Timer value must be larger than the Update Timer value. It is recommended that it be at least three times greater.

In any configuration all adjacent routers must have the same values for each of the timer parameters. It is possible to have different values for the timers on two adjacent routers, provided the Invalid Timer value is at least three times greater on one of the routers than the Update Timer value on the other router.

Example:

Router-N(configure router:rip)# timers basic 30 180

Use the timers basic command to configure the route timer.

Use the no timers basic command to restore the timers to their default values.

The syntax for this command is: timers basic <update><invalid>

update	RIP update timer in seconds (minimum = 30;
	default = 30)

226 Avaya C460 Reference Guide