Xantrex Technology GT100E Cable Installation

Cable Installation

152602 2–5

Cable Installation

The following torque specifications are to be used on all electrical

interfaces made during installation of the GT100E MS Combiner Box.

One or multiple wires up to 300 mm2 can be connected to the GT100E

MS Combiner box. Follow local Electrical codes to determine the correct

wire gauge.

M10 Bolt 40.0Nm

M12 Bolt 54.0Nm

M16 Bolt 132.0Nm

CAUTION

All wiring methods and wire gauges shall be in accordance with Local Electrical

Code. Take care to keep the wire bundles away from any sharp edges which may

damage wire insulation over time.

Contents

Main Page Page Page About This Manual Purpose Scope Audience Organization Conventions Used Related Information WARNING Important Safety Instructions WARNING Page Contents Page Figures Page Page GT100E MS Combiner Box Master/Slave Configuration Master Unit Slave Unit Master/Slave Operation States Fault Condition Mis-configuration of Units Page Equipment Required Unpacking the GT100E MS WARNING: Equipment is Heavy Unpacking the GT100E MS 152602 23 Figure 2-1 GT100E MS Componenets Mounting Instructions Cable Installation Wire Gauge and Torque Specifications Wire Gauge Requirements for the GT100E MS Combiner Box Torque Specifications for the GT100E MS Combiner Box MS100E Connections Input/Output Access Panels PV Array and GT100E Connections Page Page GT100E MS Control Power Cable Page Page Page GT100E Unit Installation Page Master/Slave Configuration Page Page Warranty and Product Information Limited Warranty 1.1 What does this warranty cover and how long does it last? 1.2 What will Xantrex do? 1.3 How do you get service? 1.4 What does this warranty not cover? 1.5 Exclusions 1.6 Limitations on Exclusions 1.7 Exclusion for Documentation 1.8 WARNING: LIMITATIONS ON USE Out of Warranty Service