Pioneer DEH-P500UB operation manual Initial Settings Adjusting initial settings, Setting the clock

	Section
Initial Settings	04

Adjusting initial settings

1Press SRC and hold until the unit turns

off.

2Press MULTI-CONTROL and hold until CLOCK SET appears in the display.

3Turn MULTI-CONTROL to select one of the initial settings.

CLOCK SET (clock)—WARNING TONE (warn- ing tone)—AUX1 (auxiliary input 1)—AUX2 (auxiliary input 2)—DIMMER (dimmer)— SW CONTROL (rear output and subwoofer controller)—BUILT-IN AMP (power amp set- ting)—DEMO MODE (feature demo)— EVER SCROLL (ever scroll)—BT AUDIO (Blue- tooth audio)—PIN CODE INPUT (pin code input)—BT VER INFO (Bluetooth version infor-

mation)

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

# You can also select the function by pressing

FUNCTION on the remote control.

# To cancel initial settings, press BAND/ESC.

# BT AUDIO, PIN CODE INPUT and

BT VER INFO can be selected only when Blue-

tooth adapter (e.g., CD-BTB200) is connected to this unit.

Setting the clock

Use these instructions to set the clock.

1Use MULTI-CONTROL to select

CLOCK SET.

2Press MULTI-CONTROL to display the

setting mode.

# Press BACK to return to the previous display.

3Press MULTI-CONTROL to select the seg- ment of the clock display you wish to set. Each time you press MULTI-CONTROL, one segment of the clock display is selected. Hour—Minute

As you select segments of the clock display, the selected segment blinks.

4Turn MULTI-CONTROL to put a clock

right.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Switching the warning tone

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone.

1Use MULTI-CONTROL to select

WARNING TONE.

2Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 30.

1Use MULTI-CONTROL to select AUX1/ AUX2.

2Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL again.

Switching the dimmer setting

To prevent the display from being too bright at night, the display is automatically dimmed when the car’s headlights are turned on. You can turn the dimmer on or off.

1 Use MULTI-CONTROL to select DIMMER.

English

En 27