Pioneer DEH-P500UB operation manual Initial Settings, Setting the internal power, Amplifier

Section

04 Initial Settings

2	Press MULTI-CONTROL to turn dimmer	Setting the internal power
on.		amplifier
#	To turn dimmer off, press MULTI-CONTROL

again.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put) can be used for full-range speaker (FULL) or subwoofer (SUB W) connection. If you switch the rear output setting to SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speak- er connection (FULL).

1Use MULTI-CONTROL to select

SW CONTROL.

2Press MULTI-CONTROL to display the

setting mode.

# Press BACK to return to the previous display.

3Use MULTI-CONTROL to select the de- sired setting.

Turn to change the setting.

SUB W (subwoofer)—FULL (full-range speak-

er)

# When no subwoofer is connected to the rear

output, select FULL.

# When a subwoofer is connected to the rear output, set for subwoofer SUB W.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 25).

!If you change this setting, subwoofer output

in the audio menu return to the factory settings.

This unit features high power amplifier. How- ever, in particular system, external amplifiers are used instead of internal amplifier. If you use external amplifiers in order to establish a multi-amp system, and don't use internal am- plifier, it is recommended to turn off the inter- nal amplifier. Turning off internal amplifier reduces the noise that comes from the beha- vior of internal amplifier and fan.

1Use MULTI-CONTROL to select

BUILT-IN AMP.

2Press MULTI-CONTROL to turn the inter-

nal power amplifier on.

# To turn the internal power amplifier off, press MULTI-CONTROL again.

Switching the feature demo

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON.

1Use MULTI-CONTROL to select

DEMO MODE.

2Press MULTI-CONTROL to turn the fea-

ture demo on.

# To turn the feature demo off, press MULTI-CONTROL again.

Notes

!Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power.

!You can also turn on or off feature demo by pressing DISP while this unit is turned off. For

more details, see About the demo mode on page 8.

28 En