Enterasys Networks 9034313-07 manual Set spantree, Show spantree version

	set spantree
Table 9-1 show spantree Output Details (Continued)
Output	What It Displays...
Bridge Hello Time	Amount of time (in seconds) the bridge sends BPDUs. This is a default
	value, or is assigned using the set spantree hello command. For details,
	refer to “set spantree hello” on page 9-18.
Bridge Forward Delay	Amount of time (in seconds) the bridge spends in listening or learning
	mode. This is a default value, or is assigned using the set spantree
	fwddelay command. For details, refer to “set spantree fwddelay” on
	page 9-20.
Topology Change Count	Number of times topology has changed on the bridge.
Time Since Top Change	Amount of time (in days, hours, minutes and seconds) since the last
	topology change.
Max Hops	Maximum number of hops information for a particular Spanning Tree
	instance may traverse (via relay of BPDUs within the applicable MST
	region) before being discarded.

set spantree

Use this command to globally enable or disable the Spanning Tree protocol on the switch.

Syntax

set spantree {disable enable}

Parameters

disable enable Globally disables or enables Spanning Tree.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to disable Spanning Tree on the device:

C3(su)->set spantree disable

show spantree version

Use this command to display the current version of the Spanning Tree protocol running on the device.

Syntax

show spantree version

Parameters

None.

SecureStack C3 Configuration Guide 9-7