Enterasys Networks 9034313-07 Show port counters, Show port status Output Details, Switch mib2

show port counters

(truncated)	Status	Status	--------	------- -------------
------------ --------------	-------	-------
ge.3.14	up	up	N/A	N/A	BaseT RJ45

Table 7‐1 provides an explanation of the command output.

Table 7-1 show port status Output Details

Output Field	What It Displays...
Port	Port designation. For a detailed description of possible port-stringvalues, refer to
	“Port String Syntax Used in the CLI” on page 7-1.
Alias (truncated)	Alias configured for the port. For details on using the set port alias command, refer
	to “set port alias” on page 7-9.
Oper Status	Operating status (up or down).
Admin Status	Whether the specified port is enabled (up) or disabled (down). For details on using
	the set port disable command to change the default port status of enabled, refer to
	“set port disable” on page 7-8.For details on using the set port enable command to
	re-enable ports, refer to “set port enable” on page 7-8.
Speed	Operational speed in Mbps or Kbps of the specified port. For details on using the set
	port speed command to change defaults, refer to “set port speed” on page 7-12.
Duplex	Duplex mode (half or full) of the specified port. For details on using the set port
	duplex command to change defaults, refer to “Setting Auto-Negotiation and
	Advertised Ability” on page 7-16.
Type	Physical port and interface type.

show port counters

Use this command to display port counter statistics detailing traffic through the device and through all MIB2 network devices.

Syntax

show port counters [port-string] [switch mib2]

Parameters

port‐string	(Optional) Displays counter statistics for specific port(s). For a detailed
	description of possible port‐string values, refer to “Port String Syntax Used
	in the CLI” on page 7‐1.
switch mib2	(Optional) Displays switch or MIB2 statistics. Switch statistics detail
	performance of the SecureStack C3 device. MIB2 interface statistics detail
	performance of all network devices.

Defaults

If port‐string is not specified, counter statistics will be displayed for all ports.

If mib2 or switch are not specified, all counter statistics will be displayed for the specified port(s).

Mode

Switch command, read‐only.

7-4 Port Configuration