Enterasys Networks 9034313-07 manual Show port ingress filter

show port ingress filter

Parameters

port‐string	Specifies the port(s) to be reset to the host VLAN ID 1. For a detailed
	description of possible port‐string values, refer to “Port String Syntax Used
	in the CLI” on page 7‐1.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to reset ports ge.1.3 through 11 to a VLAN ID of 1 (Host VLAN):

C3(su)->clear port vlan ge.1.3-11

show port ingress filter

Use this command to show all ports that are enabled for port ingress filtering, which limits incoming VLAN ID frames according to a port VLAN egress list. If the VLAN ID specified in the received frame is not on the port’s VLAN egress list, then that frame is dropped and not forwarded.

Syntax

show port ingress-filter [port-string]

Parameters

port‐string	(Optional) Specifies the port(s) for which to display ingress filtering status.
	For a detailed description of possible port‐string values, refer to “Port String
	Syntax Used in the CLI” on page 7‐1.

Defaults

If port‐string is not specified, ingress filtering status for all ports will be displayed.

Mode

Switch command, read‐only.

Example

This example shows how to display the port ingress filter status for ports 10 through 15 in slot 1. In this case, the ports are disabled for ingress filtering:

C3(su)->show port ingress-filter ge.1.10-15

Port	State
--------	---------
ge.1.10	disabled
ge.1.11	disabled
ge.1.12	disabled
ge.1.13	disabled
ge.1.14	disabled
ge.1.15	disabled

10-10 802.1Q VLAN Configuration