Enterasys Networks 9034313-07 manual Clear spantree portpri

		clear spantree portpri
Parameters
	port‐string	Specifies the port(s) for which to set Spanning Tree port priority. For a
		detailed description of possible port‐string values, refer to “Port String
		Syntax Used in the CLI” on page 7‐1.
	priority	Specifies a number that represents the priority of a link in a Spanning Tree
		bridge. Valid values are from 0 to 240 (in increments of 16) with 0
		indicating high priority.
	sid sid	(Optional) Sets port priority for a specific Spanning Tree identifier. Valid
		values are 0 ‐ 4094. If not specified, SID 0 is assumed.

Defaults

If sid is not specified, port priority will be set for Spanning Tree 0.

Mode

Switch command, read‐write.

Example

This example shows how to set the priority of ge.1.3 to 240 on SID 1

C3(su)->set spantree portpri ge.1.3 240 sid 1

clear spantree portpri

Use this command to reset the bridge priority of a Spanning Tree port to a default value of 128.

Syntax

clear spantree portpri port-string[sid sid]

Parameters

port‐string	Specifies the port(s) for which to set Spanning Tree port priority. For a
	detailed description of possible port‐string values, refer to “Port String
	Syntax Used in the CLI” on page 7‐1.
sid sid	(Optional) Resets the port priority for a specific Spanning Tree identifier.
	Valid values are 0 ‐ 4094. If not specified, SID 0 will be assumed.

Defaults

If sid is not specified, port priority will be set for Spanning Tree 0.

Mode

Switch command, read‐write.

Example

This example shows how to reset the priority of ge.1.3 to 128 on SID 1

C3(su)->clear spantree portpri ge.1.3 sid 1

SecureStack C3 Configuration Guide 9-37