Enterasys Networks 9034313-07 manual Set rmon event status, Clear rmon event

set rmon event status

Example

This example shows how to create and enable an RMON event entry called “STP topology change” that will send both a log entry and an SNMP trap message to the “public” community:

C3(rw)->set rmon event properties 2 description "STP topology change" type both community public owner Manager

set rmon event status

Use this command to enable an RMON event entry. An event entry describes the parameters of an RMON event that can be triggered. Events can be fired by RMON alarms and can be configured to create a log entry, generate a trap, or both.

Syntax

set rmon event status index enable

Parameters

index	Specifies an index number for this entry. Maximum number of entries is
	100. Maximum value is 65535.
enable	Enables this event entry.

Defaults

None.

Mode

Switch command, read‐write.

Usage

An RMON event entry can be created using this command, configured using the set rmon event properties command (“set rmon event properties” on page 15‐14), then enabled using this command. An RMON event entry can be created and configured at the same time by specifying an unused index with the set rmon event properties command.

Example

This example shows how to enable RMON event entry 1:

C3(rw)->set rmon event status 1 enable

clear rmon event

Use this command to delete an RMON event entry and any associated log entries.

Syntax

clear rmon event index

Parameters

index Specifies the index number of the entry to be cleared.

SecureStack C3 Configuration Guide 15-15