Enterasys Networks 9034313-07 Aadminstate, Lacpactive, Lacptimeout, Lacpagg lacpsync, Lacpcollect

		set port lacp
aadminstate	Sets the port’s actor LACP administrative state to allow for:
lacpactive	lacpactive ‐ Transmitting LACP PDUs.
lacptimeout
	lacptimeout ‐ Transmitting LACP PDUs every 1 sec. vs 30 sec. (default).
lacpagg lacpsync
lacpcollect	lacpagg ‐ Aggregation on this port.
lacpdist lacpdef
	lacpsync ‐ Transition to synchronization state.
lacpexpire
	lacpcollect ‐ Transition to collection state.
	lacpdist ‐ Transition to distribution state.
	lacpdef ‐ Transition to defaulted state.
	lacpexpire ‐ Transition to expired state.
aportpri aportpri	Sets the port’s actor port priority. Valid values are 0 ‐ 65535, with lower
	values designating higher priority.
asyspri asyspri	Sets the port’s actor system priority. The LACP implementation on the
	SecureStack C3 device uses this value to determine aggregation
	precedence when there are two devices competing for the same
	aggregator. Valid values are 0 ‐ 65535, with higher precedence given to
	lower values.
		Note: Only one LACP system priority can be set on a SecureStack
		C3 device, using either this command, or the set lacp asyspri
		command (“set lacp asyspri” on page 7-47).
enable	(Optional) Enables LACPDU processing on this port.
disable	(Optional) Disables LACPDU processing on this port.
padminkey	Sets a default value to use as the port’s partner admin key. Only ports with
padminkey	matching admin keys are allowed to aggregate. Valid values are 1 ‐ 65535.
padminport	Sets a default value to use as the port’s partner admin value. Valid values
padminport	are 1 ‐ 65535.
padminportpri	Sets a default value to use as the port’s partner port priority. Valid values
padminportpri	are 0 ‐ 65535, with lower values given higher priority.
padminstate	Sets a port’s partner LACP administrative state. See aadminstate for valid
lacpactive	options.
lacptimeout
lacpagg lacpsync
lacpcollect
lacpdist lacpdef
lacpexpire
padminsysid	Sets a default value to use as the port’s partner system ID. This is a MAC
padminsysid	address.
padminsyspri	Sets a default value to use as the port’s partner priority. Valid values are 0
padminsyspri	‐ 65535, with lower values given higher priority.

Defaults

At least one parameter must be entered per port‐string.

If enable or disable are not specified, port(s) will be enabled with the LACP parameters entered.

SecureStack C3 Configuration Guide 7-53