Enterasys Networks 9034313-07 manual Set port speed, Show port duplex, 10 100, Mbps

set port speed

set port speed

Use this command to set the default speed of one or more ports. This setting only takes effect on ports that have auto‐negotiation disabled.

Syntax

set port speed port-string{10 100 1000}

Parameters

port‐string	Specifies the port(s) for which to a speed value will be set. For a
	detailed description of possible port‐string values, refer to “Port
	String Syntax Used in the CLI” on page 7‐1.
10 100 1000	Specifies the port speed. Valid values are: 10 Mbps, 100 Mbps, or
	1000 Mbps.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to set ge.3.3 to a port speed of 10 Mbps:

C3(su)->set port speed ge.3.3 10

show port duplex

Use this command to display the default duplex setting (half or full) for one or more ports.

Syntax

show port duplex [port-string]

Parameters

port‐string	(Optional) Displays default duplex setting(s) for specific port(s).
	For a detailed description of possible port‐string values, refer to
	“Port String Syntax Used in the CLI” on page 7‐1.

Defaults

If port‐string is not specified, default duplex settings for all ports will be displayed.

Mode

Switch command, read‐only.

7-12 Port Configuration