Enterasys Networks 9034313-07 manual Set inlinepower threshold, Show inlinepower Output Details

set inlinepower threshold

Example

This example shows how to display system power properties:

C3(su)->show inlinepower
Detection Mode			: auto
Unit	Status	Power(W)	Consumption(W)	Usage(%)	Threshold(%)	Trap
----	------	--------	--------------	--------	------------	----
1	auto	375	0.00	0.00	80	enable

Table 5‐1 provides an explanation of the command output.

Table 5-1 show inlinepower Output Details

Output	What It Displays...
Detection Mode	Displays the PD detection mode used by the switch. The detection mode can be
	configured with the command “set inlinepower detectionmode” (page 5-3).
Unit	Number of PoE-capable module.
Status	Whether the PoE administrative state is off (disabled) or auto (on). This state is not
	configurable.
Power (W)	Unit’s available power wattage.
Consumption (W)	Unit’s power wattage consumed.
Usage (%)	Unit’s percentage of total system PoE power usage.
Threshold (%)	Unit’s alloted percentage of total PoE power available in the system. The threshold
	can be configured with the command “set inlinepower threshold” (page 5-2).
Trap	Whether PoE trap messaging is enabled or disabled on this unit. Trap messaging
	can be configured with the command “set inlinepower trap” (page 5-3).

set inlinepower threshold

Use this command to set the power usage threshold on a specified unit or module.

Syntax

set inlinepower threshold usage-threshold module-number

Parameters

usage‐threshold	Specifies a power threshold as a percentage of available system power.
	Valid values are 11 to 100.
module‐number	Specifies the module or unit on which to set the power threshold.

Defaults

None.

Mode

Switch command, read‐write.

5-2 Configuring System Power and PoE