Enterasys Networks 9034313-07 Clear snmp notifyprofile, Creating a Basic Snmp Trap Configuration

		clear snmp notifyprofile
Parameters
	profile	Specifies an SNMP filter notify name.
	targetparam	Specifies an associated entry in the SNMP Target Params Table.
	targetparam
	volatile	(Optional) Specifies a storage type.
	nonvolatile

Defaults

If storage type is not specified, nonvolatile (permanent) will be applied.

Mode

Switch command, read‐write.

Example

This example shows how to create an SNMP notify profile named area51 and associate a target parameters entry.

C3(su)->set snmp notifyprofile area51 targetparam v3ExampleParams

clear snmp notifyprofile

Use this command to delete an SNMP notify profile configuration.

Syntax

clear snmp notifyprofile profile targetparam targetparam

Parameters

profile	Specifies an SNMP filter notify name to delete.
targetparam	Specifies an associated entry in the snmpTargetParamsTable.
targetparam

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to delete SNMP notify profile “area51”:

C3(su)->clear snmp notifyprofile area51 targetparam v3ExampleParams

Creating a Basic SNMP Trap Configuration

Traps are notification messages sent by an SNMPv1 or v2 agent to a network management station, a console, or a terminal to indicate the occurrence of a significant event, such as when a port or device goes up or down, when there are authentication failures, and when power supply errors

SecureStack C3 Configuration Guide 8-37