Enterasys Networks 9034313-07 manual Clear multiauth port

clear multiauth port

Parameters

mode	Specifies the port(s)’ multiple authentication mode as:
auth‐opt	• auth‐opt — Authentication optional (“non‐strict” behavior). If a user
auth‐reqd
	does not attempt to authenticate using 802.1x, or if 802.1x
force‐auth
	authentication fails, the port will allow traffic to be forwarded
force‐unauth
	according to the defined default VLAN.
	• auth‐reqd — Authentication is required.
	• force‐auth — Authentication considered.
	• force‐unauth — Authentication disabled.
numusers	Specifies the number of users allowed authentication on port(s). Valid
numusers	values depend on your specific platform. Refer to Appendix A, Policy and
	Authentication Capacities for information about multi‐user capacities.
port‐string	Specifies the port(s) on which to set multiple authentication properties.

Defaults

Default value for the number of users allowed to authenticate on a port is 1.

Mode

Switch command, read‐write.

Examples

This example shows how to set the port multiple authentication mode to required on ge.3.14:

C3(rw)->set multiauth port mode auth-reqd ge.3.14

This example shows how to set the number of users allowed to authenticate on port ge.3.14 to 2:

C3(rw)->set multiauth port numusers 2 ge.3.14

clear multiauth port

Use this command to clear multiple authentication properties for one or more ports.

Syntax

clear multiauth port {mode numusers} port-string

Parameters

mode	Clears the specified port’s multiple authentication mode.
numusers	Clears the value set for the number of users allowed authentication on the
	specified port.
port‐string	Specifies the port or ports on which to clear multiple authentication
	properties.

Defaults

None.

26-42 Authentication and Authorization Configuration