Enterasys Networks 9034313-07 manual Authentication‐, Key key, Dead‐interval, Hello‐interval

		redistribute
Parameters
	area‐id	Specifies the transit area for the virtual link. Valid values are decimal values
		or IP addresses. A transit area is an area through which a virtual link is
		established.
	router‐id	Specifies the router ID of the virtual link neighbor.
	authentication‐	Specifies a password to be used by the virtual link. Valid values are
	key key	alphanumeric strings of up to 8 characters. Neighbor virtual link routers on
		a network must have the same password.
	dead‐interval	Specifies the number of seconds that a router must wait to receive a hello
	seconds	packet before declaring the neighbor as “dead” and removing it from the
		OSPF neighbor list. This value must be the same for all virtual links attached
		to a certain subnet, and it is a value ranging from 1 to 8192.
	hello‐interval	Specifies the number of seconds between hello packets on the virtual link.
	seconds	This value must be the same for all virtual links attached to a network and it
		is a value ranging from 1 to 8192.
	retransmit‐	Specifies the number of seconds between successive retransmissions of the
	interval seconds	same LSAs. Valid values are greater than the expected amount of time
		required for the update packet to reach and return from the interface, and
		range from 1 to 8192. Default is 5 seconds.
	transmit‐delay	Specifies the estimated number of seconds before a link state update packet
	seconds	on the interface to be transmitted. Valid values range from 1 to 8192. Default
		is 1 second.
Defaults
	None.
Mode

Router configuration: C3(su)‐>router(Config‐router)#

Example

This example shows how to configure a virtual link over transition area 0.0.0.2 to router ID 192.168.7.2:

C3(su)->router(Config)#router ospf 1

C3(su)->router(Config-router)#area 0.0.0.2 virtual-link 192.168.7.2

redistribute

Use this command to allow routing information discovered through non‐OSPF protocols to be distributed in OSPF update messages. The no form of this command clears redistribution parameters.

Syntax

redistribute {connected rip static} [metric metric value] [metric-type type- value] [subnets]

no redistribute {connected rip static}

SecureStack C3 Configuration Guide 20-25