Enterasys Networks 9034313-07 manual Default Settings for Router Operation, Sntp

Factory Default Settings

Table 1-1 Default Settings for Basic Switch Operation (Continued)

Feature	Default Setting
SNMP	Enabled.
SNTP	Disabled.
Spanning Tree	Globally enabled and enabled on all ports.
Spanning Tree edge port	Edge port administrative status begins with the value set to false initially after
administrative status	the device is powered up. If a Spanning Tree BDPU is not received on the
	port within a few seconds, the status setting changes to true.
Spanning Tree edge port	Enabled.
delay
Spanning Tree forward	Set to 15 seconds.
delay
Spanning Tree hello	Set to 2 seconds.
interval
Spanning Tree ID (SID)	Set to 0.
Spanning Tree maximum	Set to 20 seconds.
aging time
Spanning Tree port priority	All ports with bridge priority are set to 128 (medium priority).
Spanning Tree priority	Bridge priority is set to 32768.
Spanning Tree topology	Enabled.
change trap suppression
Spanning Tree version	Set to mstp (Multiple Spanning Tree Protocol).
SSH	Disabled.
System baud rate	Set to 9600 baud.
System contact	Set to empty string.
System location	Set to empty string.
System name	Set to empty string.
Terminal	CLI display set to 80 columns and 24 rows.
Timeout	Set to 5 minutes.
User names	Login accounts set to ro for Read-Only access; rw for Read-Write access;
	and admin for Super User access.
VLAN dynamic egress	Disabled on all VLANs.
VLAN ID	All ports use a VLAN identifier of 1.
Host VLAN	Default host VLAN is 1.

Not all of the following routing features are available on all platforms. Check the Release Notes for your specific platforms for details.

Table 1-2 Default Settings for Router Operation

Output...	What it displays...
Access groups (IP security)	None configured.
Access lists (IP security)	None configured.

1-4 Introduction