Enterasys Networks 9034313-07 Gvrp, Mac‐phy, Poe, Link‐aggr, Max‐frame, Med‐cap, Med‐pol, Med‐loc

		set lldp port tx-tlv
	gvrp	GVRP information defined by Protocol Identity IEEE 802.1
		Extensions TLV. If LACP is enabled on the port, value sent includes
		version of protocol being used.
	mac‐phy	MAC‐PHY Configuration/Status IEEE 802.3 Extensions TLV. Value
		sent includes the operational MAU type, duplex, and speed of the
		port.
	poe	Power via MDI IEEE 802.3 Extensions TLV. Values sent include
		whether pair selection can be controlled on port, and the power class
		supplied by the port. Only valid for PoE‐enabled ports.
	link‐aggr	Link Aggregation IEEE 802.3 Extensions TLV. Values sent indicate
		whether the link associated with this port can be aggregated,
		whether it is currently aggregated, and if aggregated, the aggregated
		port identifier.
	max‐frame	Maximum Frame Size IEEE 802.3 Extensions TLV. Value sent
		indicates maximum frame size of the port’s MAC and PHY.
	med‐cap	LLDP‐MED Capabilities TLV.Value sent indicates the capabilities
		(whether the device supports location information, network policy,
		extended power via MDI) and Device Type (network connectivity
		device) of the sending device.
	med‐pol	LLDP‐MED Network Policy TLV. Values sent include application
		name, VLAN type (tagged or untagged), VLAN ID, and both Layer 2
		and Layer 3 priorities associated with application, for all applications
		enabled on the port. See the set lldp port network‐policy command
		for more information.
	med‐loc	LLDP‐MED Location Identification TLV. Value sent is the ECS ELIN
		value configured on the port. See the set lldp port location‐info
		command for more information.
	med‐poe	LLDP‐MED Extended Power via MDI TLV. Values sent include the
		Power Limit (total power the port is capable of sourcing over a
		maximum length cable) and the power priority configured on the
		port. Only valid for PoE‐enabled ports.
	port‐string	Specifies the port or range of ports to be affected.
Defaults
	None.
Mode

Switch command, read‐write.

Example

This example configures the management address, MED capability, MED network policy, and MED location identification TLVs to be sent in LLDPDUs by port ge.1.1.

C3(rw)->set lldp port tx-tlv mgmt-addr med-cap med-pol med-loc ge.1.1

SecureStack C3 Configuration Guide 6-29