Enterasys Networks 9034313-07 manual Configuring Priority to Transmit Queue Mapping

Configuring Priority to Transmit Queue Mapping

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to reset ge.1.11 to the default priority:

C3(rw)->clear port priority ge.1.11

Configuring Priority to Transmit Queue Mapping

Purpose

To perform the following:

•View the current priority to transmit queue mapping of each physical port.

•Configure each port to either transmit frames according to the port priority, set using the set port priority command described in “set port priority” on page 12‐3, or according to a priority based on a percentage of port transmission capacity, assigned to transmit queues using the set port txq command described in “set port txq” on page 12‐8.

•Clear current port priority queue settings for one or more ports.

Commands

For information about...	Refer to page...
show port priority-queue	12-4
set port priority-queue	12-5
clear port priority-queue	12-6

show port priority-queue

Use this command to display the port priority levels (0 through 7, with 0 as the lowest level) associated with the current transmit queues (0 being the lowest priority) for each selected port. A frame with a certain port priority is transmitted according to the settings entered using the set port priority‐queue command described in “set port priority‐queue” on page 12‐5.

Syntax

show port priority-queue [port-string]

Parameters

port‐string	(Optional) Displays the mapping of priorities to transmit queues for one
	or more ports.

12-4 Port Priority Configuration