Enterasys Networks 9034313-07 manual Set spantree mstcfgid, Clear spantree mstcfgid

set spantree mstcfgid

Example

This example shows how to display the MST configuration identifier elements. In this case, the default revision level of 0, and the default configuration name (a string representing the bridge MAC address) have not been changed. For information on using the set spantree mstcfgid command to change these settings, refer to “set spantree mstcfgid” on page 9‐16:

C3(su)->show spantree mstcfgid MST Configuration Identifier:

Format Selector: 0

Configuration Name: 00:01:f4:89:51:94

Revision Level: 0

Configuration Digest: ac:36:17:7f:50:28:3c:d4:b8:38:21:d8:ab:26:de:62

set spantree mstcfgid

Use this command to set the MST configuration name and/or revision level.

Syntax

set spantree mstcfgid {cfgname name rev level}

Parameters

cfgname name Specifies an MST configuration name.

rev level Specifies an MST revision level. Valid values are 0 ‐ 65535.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to set the MST configuration name to “mstconfig”:

C3(su)->set spantree mstconfigid cfgname mstconfig

clear spantree mstcfgid

Use this command to reset the MST revision level to a default value of 0, and the configuration name to a default string representing the bridge MAC address.

Syntax

clear spantree mstcfgid

Parameters

None.

Defaults

None.

9-16 Spanning Tree Configuration