Enterasys Networks 9034313-07 manual Configuring Quality of Service QoS, Show port txq

Configuring Quality of Service (QoS)

Configuring Quality of Service (QoS)

Refer to the “Configuring QoS” Feature Guide for detailed information about configuring quality of service on the SecureStack C3. The Enterasys Networks firmware Feature Guides are available at:

http://www.enterasys.com/support/manuals

Purpose

Eight transmit queues are implemented in the switch hardware for each port. The commands in this section allow you to set the priority mode and weight for each of the available queues (0 through 7) for each physical port on the switch. Priority mode and weight cannot be configured on LAGs, only on the physical ports that make up the LAG.

Commands

For information about...	Refer to page...
show port txq	12-7
set port txq	12-8
clear port txq	12-9

show port txq

Use this command to display QoS transmit queue information for one or more physical ports.

Syntax

show port txq [port-string]

Parameters

port‐string	(Optional) Specifies port(s) for which to display QoS settings. For a
	detailed description of possible port‐string values, refer to “Port String
	Syntax Used in the CLI” on page 7‐1.
	Only physical ports will be displayed. LAG ports have no transmit queue
	information.

Defaults

If the port‐string is not specified, the QoS setting of all physical ports will be displayed.

Mode

Switch command, read‐only.

SecureStack C3 Configuration Guide 12-7