Enterasys Networks 9034313-07 manual Set lacp singleportlag, Clear lacp singleportlag

set lacp singleportlag

set lacp singleportlag

Use this command to enable or disable the formation of single port LAGs.

Syntax

set lacp singleportlag {enable disable}

Parameters

disable enable Enables or disables the formation of single port LAGs.

Defaults

None.

Mode

Switch command, read‐write.

Usage

When single port LAGs are enabled, Link Aggregration Groups can be formed when only one port is receiving protocol transmissions from a partner. When this setting is disabled, two or more ports are required to form a LAG.

This setting has no effect on existing LAGs created with multiple member ports. It also does not prevent previously formed LAGs from coming up after they have gone down, as long as any previous LAG member ports come up connected to the same switch as before the LAG went down.

Example

This example enables the formation of single port LAGs:

C3(su)->set lacp singleportlag enable

clear lacp singleportlag

Use this command to reset the single port LAG function back to the default state of disabled.

Syntax

clear lacp singleportlag

Parameters

None.

Defaults

None.

Mode

Switch command, read‐write.

7-50 Port Configuration