Enterasys Networks 9034313-07 manual Show ip ospf interface, Show ip ospf database Output Details

show ip ospf interface

191.4.0.0	155.155.155.155	1307	0x8000003c	0x8e98
Displaying Router Link States(Area 0.0.0.8)				Checksum
LinkID	ADV Router	Age	Seq#
3.3.3.3	3.3.3.3	986	0x8000008e	0xb6f9
155.155.155.155	155.155.155.155	977	0x8000009c	0x6e96
Displaying Net Link States(Area 0.0.0.8)				Checksum
LinkID	ADV Router	Age	Seq#
192.168.30.2	155.155.155.155	310	0x8000003b	0x59ab
192.168.31.2	155.155.155.155	997	0x80000002	0xc07c
192.168.32.2	155.155.155.155	997	0x80000002	0xb586
192.168.33.2	155.155.155.155	998	0x80000002	0xaa90
Displaying Ipnet Sum Link States(Area 0.0.0.8)				Checksum
LinkID	ADV Router	Age	Seq#
0.0.0.0	3.3.3.3	361	0x80000005	0x311d
8.1.1.0	3.3.3.3	1512	0x80000003	0x3de1
8.1.2.0	3.3.3.3	1512	0x80000003	0x32eb
8.1.3.0	3.3.3.3	1502	0x80000003	0x27f5
8.1.4.0	3.3.3.3	1512	0x80000003	0x1c00

Table 20‐3 provides an explanation of the command output.

Table 20-3 show ip ospf database Output Details

Output Field	What It Displays...
Link ID	Link ID, which varies as a function of the link state record type, as follows:
	• Net Link States - Shows the interface IP address of the designated router to the
	broadcast network.
	• Router Link States - Shows the ID of the router originating the record.
	• Summary Link States - Shows the summary network prefix.
ADV Router	Router ID of the router originating the link state record.
Age	Age (in seconds) of the link state record.
Seq#	OSPF sequence number assigned to each link state record.
Checksum	Field in the link state record used to verify the contents upon receipt by another
	router.
LinkCount	Link count of router link state records. This number is equal to, or greater than, the
	number of active OSPF interfaces on the originating router.

show ip ospf interface

Use this command to display OSPF interface related information, including network type, priority, cost, hello interval, and dead interval.

Syntax

show ip ospf interface [vlan vlan-id]

Parameters

vlan vlan‐id	(Optional) Displays OSPF information for a specific VLAN. This VLAN
	must be configured for IP routing as described in “Pre‐Routing
	Configuration Tasks” on page 18‐1.

20-28 IPv4 Routing Protocol Configuration