ip vrrp authentication-key

ip vrrp authentication-key

Use this command to enable or disable a VRRP authentication key (password) for use on an interface. The no form of this command prevents VRRP from using authentication.

Syntax

ip vrrp authentication-key name no ip vrrp authentication-key

Parameters

name

Specifies the password to enable or disable for VRRP authentication.

Defaults

None.

Mode

Interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#

Example

This example shows how to set the VRRP authentication key chain to “password” on the VLAN 1 interface:

C3(su)->router(Config)#interface vlan 1

C3(su)->router(Config-if(Vlan 1))#ip vrrp authentication-key password

show ip vrrp

Use this command to display VRRP routing information.

Syntax

show ip vrrp

Parameters

None.

Defaults

None.

Mode

Any router mode.

Example

This example shows how to display VRRP information

C3(su)->router(Config)#show ip vrrp

-----------Vlan

VRRP

CONFIGURATION-----------

AssocIpAddr

Priority

Vrid

State

Owner

2

1

Initialize

0

25.25.2.1

100

20-48 IPv4 Routing Protocol Configuration

Page 618
Image 618
Enterasys Networks 9034313-07 Ip vrrp authentication-key, Show ip vrrp, This example shows how to display Vrrp information