Enterasys Networks 9034313-07 manual Show lldp

show lldp

Step	Task	Command(s)
1.	Configure global system LLDP parameters	set lldp tx-interval
		set lldp hold-multiplier
		set lldp trap-interval
		set lldp med-fast-repeat
		clear lldp

2.Enable/disable specific ports to:

•Transmit and process received LLDPDUs

•Send LLDP traps

•Send LLDP-MED traps

set/clear lldp port status set/clear lldp port trap set/clear lldp port med-trap

3.	Configure an ECS ELIN value for specific ports	set/clear lldp		port location-info
4.	Configure Network Policy TLVs for specific ports	set/clear	lldp	port network-policy
5.	Configure which optional TLVs should be sent by	set/clear	lldp	tx-tlv

specific ports. For example, if you configured an ECS ELIN and/or Network Policy TLVs, you must enable those optional TLVs to be transmitted on the specific ports.

show lldp

Use this command to display LLDP configuration information.

Syntax

show lldp

Parameters

None.

Defaults

None.

Mode

Switch command, read‐only.

Example

This example shows how to display LLDP configuration information.

C3(ro)->show lldp	: 30
Message Tx Interval
Message Tx Hold Multiplier	: 4
Notification Tx Interval	: 5
MED Fast Start Count	: 3
Tx-Enabled Ports	: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Rx-Enabled Ports	: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Trap-Enabled Ports	: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
MED Trap-Enabled Ports	: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;

SecureStack C3 Configuration Guide 6-15