Enterasys Networks 9034313-07 manual Show port lacp, Status detail, Summary Counters

show port lacp

Example

This example shows how to reset the single port LAG function back to disabled:

C3(su)->clear lacp singleportlag

show port lacp

Use this command to display link aggregation information for one or more underlying physical ports.

Syntax

show port lacp port port-string{[status {detail summary}] [counters]}

Parameters

port port‐string	Displays LACP information for specific port(s). For a detailed description
	of possible port‐string values, refer to “Port String Syntax Used in the CLI”
	on page 7‐1.
status detail	Displays LACP status in detailed or summary information.
summary
counters	Displays LACP counter information.

Defaults

None.

Mode

Switch command, read‐only.

Usage

State definitions, such as ActorAdminState and Partner AdminState, are indicated with letter abbreviations. If the show port lacp command displays one or more of the following letters, it means the state is true for the associated actor or partner ports:

•E = Expired

•F = Defaulted

•D = Distributing (tx enabled)

•C = Collecting (rx enabled)

•S = Synchronized (actor and partner agree)

•G = Aggregation allowed

•S/l = Short/Long LACP timeout

•A/p = Active/Passive LACP

For more information about these states, refer to set port lacp (page 7‐52) and the IEEE 802.3 2002 specification.

Examples

This example shows how to display detailed LACP status information for port ge.1.12:

C3(su)-> show port lacp port ge.1.12 status detail

SecureStack C3 Configuration Guide 7-51