CHAPTER 3

Operating the TGR-401 with the Remote

1.Press the remote's MAIN button to make sure the display is on the main display menu.

2.Press the TG401

device button to set the remote to operate your TGR- 401. The display changes to show the TGR-401 input selections.

MAIN

PAGE

ONOFF

PAGE MAIN FAV

PREV

MUTE CH

VOLCH

ZONE 2

TG401

Hold down MAIN and ENT for a few seconds to enter the SETUP mode. See next page.

3.Press PAGE to reach three more pages of the menu.

Page 2 shows selec- tion of the front panel input, the SIRIUS tuner op- tion, FM tuner, AM tuner, FRTMD (front mode), and TN- MOD (tuner mode).

Page 3 shows:DIM– and DIM+ allow you

Full-page On Screen

GUIDE

 

OSD Exit

Display (OSD)

INFO

 

 

MENU

 

EXIT

 

Previous Mode

SEL

 

Next Mode

 

 

 

Use this area to

 

 

 

navigate through the

1

2

3

OSD (when active)

4

5

6

 

7

8

9

 

+10

0

ENT

ENT

ZONE 2

Zone 2 Pages

to dim the TGR-401 display.

DHP ON and OFF allow you to turn the Dolby Head- phone circuit on or off.

HOL ON and OFF

 

allow you to turn

 

the Sonic Hologra-

TGR-401 Pages

phy on or off.

 

Page 4 allows you to adjust the volume trims for center, surrounds, and sub, and adjust the bass and treble. On the right is '+' (increase level) and on the left is '-' (de- crease level).

4.The following buttons are also programmed: ON, OFF, VOL*, and MUTE*. MENU and EXIT allow you to enter and leave the OSD menus, and the navigation buttons let you move through the OSD menus. INFO shows details of the

26

current surround mode, and extra details if MP3 or SIRIUS are cho- sen as inputs. The number pad ac- cesses the tuner presets or direct tuning, and CH+/- steps through stations or presets (depending on the tuning mode TNMOD). The MODE buttons on either side of the navigation pad allow you to select the different surround modes and offers detailed tuning features for controlling your SIRIUS satellite radio.

*VOL and MUTE operate the TGR- 401, even when the remote is set to operate other source compo- nents. See PUNCH on page 28.

5. The pre-programmed MP3 menu allows

you to control the op- tional VIA!migo iPod dock. In this mode, the navigation and other buttons allow you to select song

titles, play, pause and stop selec- tions.

1.From the main display menu, press ZONE2 to access features of the second zone. Page 1 shows the input selections including the front panel input.

2.In this mode, the hard buttons operate Zone 2, such as Power, Volume, Mute, and the Tuner con- trols and presets.

3.Press PAGE to reach two other pages of the menu.

Page 2 shows some other Zone 2 input selections.

Page 3 shows the adjustments for Zone 2 balance, bass, and treble.

Note: Zone 2 can be turned on even if the Main Zone is off.

See page 48 for more Zone 2 details.

User's Manual

Page 26
Image 26
Sunfire TGR-401-230 manual Operating the TGR-401 with the Remote, Zone