Sunfire TGR-401-230 manual EQ Adjustment, OSD Menus, Conclusion

CHAPTER 1

Manual Setup

There are three main manual ad- justments that can be made using the SPEAKERS OSD menu:

1.The SPEAKER SIZE menu al- lows you to enter the crossover frequency of each speaker. Using bass management, any bass below the crossover frequency will be redirected to your subwoofer.

2.The LEVEL CALIBRATION menu allows you to adjust the level of each speaker until they are all playing at the same level. (The level calibration test tones are also a quick way to check that all your speakers are working.)

3.The SPEAKER DISTANCE menu allows you to enter the distance that each speaker is away from your listening position. The TGR- 401 then calculates the delay times.

MAIN MENU
TRIMS
TONE CONTROLS
MODES
PRESETS
SETUP
SETUP
INPUTS
SPEAKERS
VIDEO
MAIN ZONE
ZONE 2
CONTROL
DIGITAL OUT	DN MIX/THRU
DIMMER	LOW/MEDIUM/HIGH

SPEAKERS

AUTO SETUP

SPEAKER SIZE

DISTANCE

LEVEL CALIBRATION

EQ

BINDING POSTS

Auto Setup (see page 40)

Manual adjustments (see page 39)

Manual or Auto EQ adjustment (see page 41)

Details of the manual setup proce- dure are shown on page 39.

EQ Adjustment

The measurement microphone can also be used to measure the system response and adjust the EQ auto- matically. This will provide a smooth response and remove room effects.

Alternatively, the EQ of pairs of speakers, or all speakers can be ad- justed manually to suit your taste.

Details of the auto-EQ and manual EQ adjustment are shown on page 41.

OSD Menus

The SPEAKERS menu is used to

run the auto-setup, manual setup, and EQ adjustment.

1.Press the MENU button on the re- mote to bring up the MAIN MENU of the OSD on your TV.

2.Use the navigation pad left, right, up and down buttons to navigate through the menus in the next steps.

NOTE: Quit the OSD at any time by pressing the nearby EXIT but- ton. Any changes will be saved.

There is no need to navigate back through previous pages, unless you want to make more changes. The TGR-401 front panel display shows the same messages as the OSD.

3.In the MAIN MENU, select SETUP, and from there select the SPEAKERS Menu.

4.In the SPEAKERS menu are the options for AUTO SETUP, SPEAKER SIZE, DISTANCE, LEVEL CALIBRATION, and EQ.

5.When you have finished the setup and/or EQ adjustment, press the remote’s EXIT button to quit the OSD.

Conclusion

Once the automatic setup or manual setup is finished, and any EQ adjustments made, the TGR-401 is setup correctly and ready for action.

If you play a Dolby Digital or DTS encoded source, the TGR-401 will au- tomatically select the correct surround mode. If it is a 2-channel source, you can select a surround mode using the remote’s MODE buttons or from the front panel.

The TGR-401 has many more options that are described in further detail in this manual. These options will help you customize the TGR-401 to suit your tastes. You can do this after you have used the TGR-401 for a while and have a better idea of how you would like to customize your system.

User's Manual