Sunfire TGR-401-230 manual Remote Control

Remote Control

The TGR-401 remote control is

many remotes in one. There are ten device buttons, five on either side of the display, and each allows the remote to operate one piece of equip- ment.

From the factory, the device buttons on page 1 are labeled: HD/BD, SAT, DVR, MP3, DVD, CABLE, VCR, CD, ZONE2, and TG401.

Only the TG401, ZONE2 and MP3 buttons are pre-programmed, and these allow the remote to operate your TGR-401, Zone 2 and the optional VIA!migo iPod dock. The remote can be set to operate your other remote controlled equipment. This is done in three ways from the hidden SETUP menu:

CHAPTER 3

Light

The button on the right side of the remote briefly turns on the lights for the buttons and display. Pressing it again will turn it off. The number of seconds can be varied, or it can be disabled.

ON

IR WINDOW

OFF

LCD

LIGHT

Device Buttons	DEVICE
Once you press a device button,
	Buttons
all the device buttons change label
and function to become buttons to op-
erate your device. There are multiple	PAGE
pages per device, and you can move
	PAGE
between them using the PAGE button.	MAIN
PAGE
	VOL
Use this to jump to various display
pages. For example, if you press the

DEVICE

Buttons

FAV

MAIN FAV

PREV

MUTE CH

CH

GUIDE

1.Entering a code from the tables at the end of this manual

2.Stepping through the codes

3.Learning from your other remotes

TG401 device button, the display	MENU
changes to show buttons that control
your TGR-401. If you press PAGE, the
display will move to page 2, showing
more functions for the TGR-401.
MAIN

INFO

SEL

EXIT

Navigation

See Remote Setup on page 27 for more details.

LCD Display

The top line shows the present device, mode or status, and it shows when a remote command is being transmitted. The bottom line shows the page number, status and basic instructions during programming.

The main part of the display shows the labels of the ten device buttons. You can change any label and cus- tomize the remote to fit your system. Note: this is not a touch-sensitive screen, just a way of labeling the device buttons on each side, and showing instructions and status.

Contrast

The contrast of the display can be changed by holding down the MAIN button and pressing the navigation pad UP or DOWN.

	1
This button will return the remote	4
display back to the Main menu.
Depending on which mode you are	7
in, it may take two or more presses.	+10
This will help you get back to the Main
menu if you get lost in the menus.

2 3

56

89

0ENT

FAV

This button allows you to step through five display pages of your favorite TV and radio stations. These can be set and re-labeled to suit.

Navigation Pad

This pad and surrounding buttons are used to operate standard DVD menus, and VCR and Tape transport controls. In TGR-401 mode, if you press MENU, the On Screen Display will appear and the navigation buttons can be used to select and adjust the various items.

Batteries

The remote takes four AAA bat- teries inside the rear compartment. These should last about six months in normal use, before a low-battery warning appears.

User's Manual

25