Enterasys Networks 9034313-07 manual Set cdp state, Auto disable, Enable

	set cdp state
Table 6-1 show cdp Output Details (Continued)
Output Field	What It Displays...
CDP Authentication	Authentication code for CDP discovery protocol. The default of 00-00-00-00-00-00-
Code	00-00 can be reset using the set cdp auth command. For details, refer to “set cdp
	auth” on page 6-4.
CDP Transmit	Frequency (in seconds) at which CDP messages can be transmitted. The default of
Frequency	60 seconds can be reset with the set cdp interval command. For details, refer to “set
	cdp interval” on page 6-4.
Port	Port designation. For a detailed description of possible port-stringvalues, refer to
	“Port String Syntax Used in the CLI” on page 7-1.
Status	Whether CDP is enabled, disabled or auto-enabled on the port.

set cdp state

Use this command to enable or disable the CDP discovery protocol on one or more ports.

Syntax

set cdp state {auto disable enable} [port-string]

Parameters

auto disable	Auto‐enables, disables or enables the CDP protocol on the specified port(s).
enable	In auto‐enable mode, which is the default mode for all ports, a port
	automatically becomes CDP‐enabled upon receiving its first CDP message.
port‐string	(Optional) Enables or disables CDP on specific port(s). For a detailed
	description of possible port‐string values, refer to “Port String Syntax Used
	in the CLI” on page 7‐1.

Defaults

If port‐string is not specified, the CDP state will be globally set.

Mode

Switch command, read‐write.

Examples

This example shows how to globally enable CDP:

C3(su)->set cdp state enable

This example shows how to enable the CDP for port ge.1.2:

C3(su)->set cdp state enable ge.1.2

This example shows how to disable the CDP for port ge.1.2:

C3(su)->set cdp state disable ge.1.2

SecureStack C3 Configuration Guide 6-3