Enterasys Networks 9034313-07 Clear sflow port sampler, Set sflow interface, Maxheadersize, Rate

sFlow Configuration			clear sflow port sampler
ge.1.2	1	1024	128
ge.1.3	1	1024	128
ge.1.4	1	1024	128
ge.1.5	1	1024	128
ge.1.6	1	1024	128
ge.1.7	1	1024	128
ge.1.8	1	1024	128

clear sflow port sampler

Use this command to change the sampler rate or maximum header size, or to remove sampler instances.

Syntax

clear sflow port port-stringsampler [maxheadersize rate]

Parameters

port‐string	Specifies the port or ports on which the sampler instance is being
	cleared.
maxheadersize	(Optional) Specifies that the maximum header size should be cleared to
	the default value of 128 bytes.
rate	(Optional) Specifies that the sampling rate should be cleared to the
	default value of 0, which disables sampling by the instance.

Defaults

If neither optional parameter is specified, the sampler instance is cleared.

Mode

Switch command, read‐write.

Example

This example removes the sampler instance on port ge.1.1.

C3(su)->clear sflow port ge.1.1 sampler

set sflow interface

Use this command to specify the interface used for the source IP address of the sFlow Agent when sending sampling datagrams to the sFlow Collector.

Syntax

set sflow interface {loopback loop-IDvlan vlan-ID}

Parameters

loopback loop‐ID Specifies the loopback interface to be used. The value of loop‐ID can range from 0 to 7.

28-14