Enterasys Networks 9034313-07 manual Set switch, Example, Priority value, Renumber newunit

set switch

Parameters

unit (Optional) Specifies the switch unit ID, an integer ranging from 1 to 8.

Defaults

None.

Mode

Switch command, read‐only.

Example

This example shows how to display data and error information on stack ports:

C3(ro)->show switch stack-ports					------------RX
		Data------------	TX--------------
	Stacking		Error	Total	Data	Error	Total
Switch		Rate	Rate		Rate	Rate
	Port	(Mb/s)	(Errors/s)	Errors	(Mb/s)	(Errors/s)	Errors
1------	----------	------	----------	----------	------	----------	--------
	Up	0	0	0	0	0	0
	Down	0	0	0	0	0	0

set switch

Use this command to assign a switch ID, to set a switch’s priority for becoming the management switch if the previous management switch fails, or to change the switch unit ID for a switch in the stack.

Syntax

set switch {unit [priority value renumber newunit]}

Parameters

unit	Specifies a unit number for the switch. Value can range from 1 to 8.
priority value	Specifies a priority value for the unit. Valid values are 1 to 15 with higher
	values assigning higher priority.
renumber newunit	Specifies a new number for the unit.
		Note: This number must be a previously unassigned unit ID number.

Defaults

None.

Mode

Switch command, read‐write.

SecureStack C3 Configuration Guide 2-9