Enterasys Networks 9034313-07 Set system name, ‐5 provides an explanation of the command output

set system name

Model	Serial #	Versions
--------------	-----------------	-------------------
C3G124-48P	001188021035	Hw:BCM5665 REV 17
		Bp:01.00.29
		Fw:6.03.xx.xxxx
		BuFw:03.01.13
		PoE:500_3

Table 3‐5 provides an explanation of the command output.

Table 3-5 show version Output Details

Output Field	What It Displays...
Model	Switch’s model number.
Serial #	Serial number of the switch.
Versions	• Hw: Hardware version number.
	• Bp: BootPROM version.
	• Fw: Current firmware version number.
	• BuFw: Backup firmware version number.
	• PoE: Power over Ethernet driver version. (Displays only for PoE switches.)

set system name

Use this command to configure a name for the system.

Syntax

set system name [string]

Parameters

string (Optional) Specifies a text string that identifies the system.

Note: A name string containing a space in the text must be enclosed in quotes as shown in the example below.

Defaults

If string is not specified, the system name will be cleared.

Mode

Switch command, read‐write.

Example

This example shows how to set the system name to Information Systems:

C3(su)->set system name “Information Systems”

SecureStack C3 Configuration Guide 3-27