Enterasys Networks 9034313-07 manual Set ciscodp holdtime, Set ciscodp port

set ciscodp holdtime

Parameters

seconds	Specifies the number of seconds between Cisco DP PDU transmissions.
	Valid values are from 5 to 254 seconds.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to set the Cisco DP timer to 120 seconds.

C3(su)->set ciscodp timer 120

set ciscodp holdtime

Use this command to set the time to live (TTL) for Cisco discovery protocol PDUs. This is the amount of time, in seconds, neighboring devices will hold PDU transmissions from the sending device.

Syntax

set ciscodp holdtime hold-time

Parameters

hold‐time	Specifies the time to live for Cisco DP PDUs. Valid values are from 10 to 255
	seconds.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to set Cisco DP hold time to 180 seconds:

C3(su)->set ciscodp hold-time 180

set ciscodp port

Use this command to set the status, voice VLAN, extended trust mode, and CoS priority for untrusted traffic for the Cisco Discovery Protocol on one or more ports.

Syntax

set ciscodp port {[status {disable enable}] [vvid {vlan-id none dot1p untagged}] [trusted {yes no}] [cos value]} port-string

6-10 Discovery Protocol Configuration