Enterasys Networks 9034313-07 Port Configuration Summary, Port String Syntax Used in the CLI

7

Port Configuration

This chapter describes the Port Configuration set of commands and how to use them.

For information about...	Refer to page...
Port Configuration Summary	7-1
Reviewing Port Status	7-2
Disabling / Enabling and Naming Ports	7-7
Setting Speed and Duplex Mode	7-11
Enabling / Disabling Jumbo Frame Support	7-14
Setting Auto-Negotiation and Advertised Ability	7-16
Setting Flow Control	7-22
Setting Port Link Traps and Link Flap Detection	7-24
Configuring Broadcast Suppression	7-33
Port Mirroring	7-36
Link Aggregation Control Protocol (LACP)	7-42
Configuring Protected Ports	7-56

Port Configuration Summary

Port String Syntax Used in the CLI

Commands requiring a port‐string parameter use the following syntax to designate port type, slot location, and port number:

port type.unit_or_slot number.port number

Where port type can be: fe for 100‐Mbps Ethernet ge for 1‐Gbps Ethernet tg for 10‐Gbps Ethernet host for the host port vlan for vlan interfaces

lag for IEEE802.3 link aggregation ports

Where unit_or_slotnumber can be: 1 ‐ 8 for switch units in a stack

SecureStack C3 Configuration Guide 7-1