Enterasys Networks 9034313-07 manual Introduction, SecureStack C3 CLI Overview

1

Introduction

This chapter provides an overview of the SecureStack C3’s unique features and functionality, an overview of the tasks that may be accomplished using the CLI interface, an overview of ways to manage the switch, factory default settings, and information about how to use the Command Line Interface to configure the switch.

For information about...	Refer to page...
SecureStack C3 CLI Overview	1-1
Switch Management Methods	1-1
Factory Default Settings	1-2
Using the Command Line Interface	1-6

SecureStack C3 CLI Overview

The Enterasys Networks SecureStack C3 CLI interface allows you to perform a variety of network management tasks, including the following:

•Use CLI commands to perform network management and switch configuration operations.

•Download a new firmware image.

•Assign IP address and subnet mask.

•Select a default gateway.

•Establish and manage Virtual Local Area Networks (VLANs).

•Establish and manage policy profiles and classifications.

•Establish and manage priority classification.

•Configure IPv4 routing and routing protocols.

•Configure IPv6 routing and routing protocols, including OSPFv3.

•Configure security protocols, including 802.1X and RADIUS, SSHv2, PWA, MAC locking, and MAC authentication.

•Configure access control lists (ACLs).

Switch Management Methods

The SecureStack C3 switch can be managed using the following methods:

•Locally using a VT type terminal connected to the console port.

•Remotely using a VT type terminal connected through a modem.

SecureStack C3 Configuration Guide 1-1