Configuring Access Lists

Configuring Access Lists

Router: These commands can be executed when the device is in router mode only. For details on how to enable router configuration modes, refer to Enabling Router Configuration Modes” on page 18-2.

Note: Refer to the Release Notes for your product for any limitations that may apply to access control lists.

Purpose

To review and configure security access control lists (ACLs), which permit or deny access to routing interfaces based on protocol and IP address restrictions.

Commands

For information about...

Refer to page...

 

 

show access-lists

26-82

 

 

access-list (standard)

26-83

 

 

access-list (extended)

26-84

 

 

ip access-group

26-86

 

 

show access-lists

Use this command to display configured IP access lists when operating in router mode.

Syntax

show access‐lists [number]

Parameters

access‐list‐

(Optional) Displays access list information for a specific access list number.

number

Valid values are between 1 and 199.

 

 

Defaults

If number is not specified, the entire table of access lists will be displayed.

Mode

Any router mode.

Example

This example shows how to display IP access list number 145. This is an extended access list, which permits or denies ICMP, UDP and IP frames based on restrictions configured with one of the access‐list commands. For details on configuring standard access lists, refer to “access‐list (standard)” on page 26‐83. For details on configuring extended access lists, refer to “access‐list (extended)” on page 26‐84.

26-82 Authentication and Authorization Configuration

Page 828
Image 828
Enterasys Networks 9034313-07 manual Configuring Access Lists, Show access-lists, Show access‐lists number