Enterasys Networks 9034313-07 manual Show spantree operedge

		show spantree operedge
Parameters
	port‐string	Specifies port(s) on which to reset edge port status. For a detailed
		description of possible port‐string values, refer to “Port String Syntax Used
		in the CLI” on page 7‐1.
Defaults
	None.
Mode

Switch command, read‐write.

Example

This example shows how to reset ge.1.11 as a non‐edge port:

C3(su)->clear spantree adminedge ge.1.11

show spantree operedge

Use this command to display the Spanning Tree edge port operating status for a port.

Syntax

show spantree operedge [port port-string]

Parameters

port port‐string Displays edge port operating status for specific port(s).

Defaults

If port‐string is not specified, edge port operating status will be displayed for all Spanning Tree ports.

Mode

Switch command, read‐only.

Example

This example shows how to display the edge port status for ge.2.7:

C3(rw)->show spantree operedge port ge.2.7

Port ge.2.7 has a Port Oper Edge of Edge-Port

SecureStack C3 Configuration Guide 9-41