Enterasys Networks 9034313-07 manual Set cos port-resource irl

set cos port-resource irl

Mode

Switch command, read‐write.

Usage

The default port group 0.0 cannot be deleted.

Example

This example deletes all IRL Port Groups except for the Default group 0.0:

C3(su)->clear cos port-config irl all

set cos port-resource irl

Use this command to set the inbound rate limit parameters for a specific IRL resource for a specific port group.

Syntax

set cos port-resource irl group-type-indexirl-index{[unit {kbps}] [rate rate] [type {drop}]}[syslog enable disable] [trap enabledisable]

Parameters

group‐type‐index	Specifies an inbound rate limiting port group/type index. Valid entries are
	in the form of group#.port‐type.
	Valid values for group# can range from 0 to 7. Valid values for port‐type
	can range from 0 to 1, although only port type 0 is currently supported.
	For example, port group 3 would be specified as 3.0.
irl‐index	Index number of the inbound rate limiter resource associated with this
	entry. Valid values range from 0 to 99.
unit	Unit of measure for the inbound rate limiter (only option is Kbps).
kbps	Kilobits per second.
rate rate	Data rate for this inbound rate limiter. This is the actual rate limit. Valid
	values range from 512 to 1,000,000 Kbps for a Gigabit port.
type drop	Action for the rate limiter. The only action option is drop the frame if all
	limiters are exceeded.
syslog	Enable or disable reporting a syslog entry if limiters are exceeded.
enabledisable
trap enabledisable	Enable or disable sending a trap if limiters are exceeded.

Defaults

None.

Mode

Switch command, read‐write.

SecureStack C3 Configuration Guide 11-27