Enterasys Networks 9034313-07 manual Set ciscodp status, Set ciscodp timer

	set ciscodp status
Table 6-3 show ciscodp port info Output Details
Output Field	What It Displays...
Port	Port designation. For a detailed description of possible port-stringvalues, refer to
	“Port String Syntax Used in the CLI” on page 7-1.
State	Whether Cisco DP is enabled, disabled or auto-enabled on the port. Default state of
	enabled can be changed using the set ciscodp port command.
vvid	Whether a voice VLAN ID has been set on this port. Default of none can be changed
	using the set ciscodp port command.
trusted	The trust mode of the port. Default of trusted can be changed using the set ciscodp
	port command.
cos	The Class of Service priority value for untrusted traffic. The default of 0 can be
	changed using the set ciscodp port command.

set ciscodp status

Use this command to enable or disable the Cisco discovery protocol globally on the switch.

Syntax

set ciscodp state {auto disable enable}

Parameters

auto	Globally enable only if Cisco DP PDUs are received.
disable	Globally disable Cisco discovery protocol.
enable	Globally enable Cisco discovery protocol.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to globally enable CiscoDP:

C3(su)->set ciscodp state enable

set ciscodp timer

Use this command to set the number of seconds between Cisco discovery protocol PDU transmissions.

Syntax

set ciscodp timer seconds

SecureStack C3 Configuration Guide 6-9