Enterasys Networks 9034313-07 manual Set lacp, Show lacp Output Details

set lacp

Table 7-7 show lacp Output Details

Output Field	What It Displays...
Global Link	Shows if LACP is enabled or disabled on the switch.
Aggregation state
Single Port LAGs	Displays if the single port LAG feature has been enabled on the switch. See “set lacp
	singleportlag” on page 7-50for more about single port LAG.
Aggregator	LAG port designation. Each SecureStack C3 module provides 6 virtual link
	aggregator ports, which are designated in the CLI as lag.0.1 through lag.0.6. Once
	underlying physical ports (for example, fe.x.x) are associated with an aggregator
	port, the resulting Link Aggregation Group (LAG) is represented with a lag.x.x port
	designation.
Actor	Local device participating in LACP negotiation.
Partner	Remote device participating in LACP negotiation.
System Identifier	MAC addresses for actor and partner.
System Priority	System priority value which determines aggregation precedence. Only one LACP
	system priority can be set on a SecureStack C3 device, using either the set lacp
	asyspri command (page 7-47), or the set port lacp command (page 7-52).
Admin Key	Port’s assigned key. SecureStack C3 devices provide a default admin key value of
	32768 for all LAG ports (lag.0.1 though lag.0.6).
Oper Key	Port’s operational key, derived from the admin key. Only underlying physical ports
	with oper keys matching the aggregator’s will be allowed to aggregate.
Attached Ports	Underlying physical ports associated with this aggregator.

set lacp

Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the device.

Syntax

set lacp {disable enable}

Parameters

disable enable Disables or enables LACP.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example shows how to disable LACP:

C3(su)->set lacp disable

7-46 Port Configuration