Enterasys Networks 9034313-07 manual Show cos port-config, Should be displayed

show cos port-config

through 7) can be configured. Currently, only one port type (type 0) is supported. This port type supports 100 limiters.

Additional port groups may be created for flexibility. Ports assigned to a new port group must be mutually exclusive from the other port group entries—ports are automatically removed from the default port group—and must be comprised of the same port type as defined by the port group.

The creation of additional port groups could be used to combine similar ports by their function for flexibility. For instance, ports associated to users can be added to a port group called “Users” and ports associated to uplink ports can be added to a port group called “Uplink.” Using these port groups, a single class of service can assign different rate limits to each port group. “User” ports can be assigned one rate limit, while “Uplink” ports can be assigned another.

The command show cos port‐config displays each port group configured by group and type, with the group name and associated (assigned) ports. The command show cos port‐type displays the available inbound rate limiting resources for the port type.

Example

This example configures two port groups, one for user ports and one for uplink ports and assign ports to the groups. Port group 1.0 will represent user ports, group 2.0 will represent uplink ports.

C3(su)->set cos port-config irl 1.0 name Users ports ge.1.1-46

C3(su)->set cos port-config irl 2.0 name Uplink ports ge.1.47-48

show cos port-config

Use this command to show CoS port groups and the assigned ports.

Syntax

show cos port-config [irlflood-ctrl [group-type-index]]

Parameters

irl	(Optional) Specifies that inbound rate limiting configuration information
	should be displayed.
flood‐ctrl	(Optional) Specifies that flood control rate configuration information
	should be displayed.
group‐type‐index	(Optional) Show assigned ports for a specific port group. Valid entries are
	in the form of group#.port‐type.
	Valid values for group# can range from 0 to 7. Valid values for port‐type
	can range from 0 to 1, although only port type 0 is currently supported.
	For example, port group 3 would be specified as 3.0.

Defaults

The show cos port‐config command by itself will show all Port Groups.

Mode

Switch command, read‐only.

SecureStack C3 Configuration Guide 11-25