Enterasys Networks 9034313-07 manual Set lldp med-fast-repeat

		set lldp med-fast-repeat
Parameters
	frequency	Specifies the minimum time between LLDP trap transmissions, in
		seconds. The value can range from 5 to 3600 seconds. The default
		value is 5 seconds.
Defaults
	None.
Mode

Switch command, read‐write.

Example

This example sets the minimum interval between LLDP traps to 10 seconds.

C3(rw)->set lldp trap-interval 10

set lldp med-fast-repeat

Network connectivity devices transmit only LLDP TLVs in LLDPDUs until they detect that an LLDP‐MED endpoint device has connected to a port. At that point, the network connectivity device starts sending LLDP‐MED TLVs at a fast start rate on that port. Use this command to set the number of successive LLDPDUs (with LLDP‐MED TLVs) to be sent for one complete fast start interval.

Syntax

set lldp med-fast-repeat count

Parameters

count	Specifies the number of fast start LLDPDUs to be sent when an
	LLDP‐MED endpoint device is detected. Value can range from 1 to
	10. Default is 3.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example sets the number of fast start LLDPDUs to be sent to 4.

C3(rw)->set lldp med-fast-repeat 4

SecureStack C3 Configuration Guide 6-25