Enterasys Networks 9034313-07 manual Ip ospf hello-interval, Ip ospf dead-interval, 65535

ip ospf hello-interval

Example

This example shows how to set the time required to transmit a link state update packet on the VLAN 1 interface at 20 seconds:

C3(su)->router(Config)#interface vlan 1

C3(su)->router(Config-if(Vlan 1))#ip ospf transmit-delay 20

ip ospf hello-interval

Use this command to set the number of seconds a router must wait before sending a hello packet to neighbor routers on an interface. The no form of this command sets the hello interval value to the default value of 10 seconds.

Syntax

ip ospf hello-interval seconds no ip ospf hello-interval

Parameters

seconds	Specifies the hello interval in seconds. Hello interval must be the same on
	neighboring routers (on a specific subnet), but can vary between subnets.
	This parameter is an unsigned integer with valid values between 1 and
	65535.

Defaults

None.

Mode

Interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#

Example

This example shows how to set the hello interval to 5 for the VLAN 1 interface:

C3(su)->router(Config)#interface vlan 1

C3(su)->router(Config-if(Vlan 1))#ip ospf hello-interval 5

ip ospf dead-interval

Use this command to set the number of seconds a router must wait to receive a hello packet from its neighbor before determining that the neighbor is out of service. The no form of this command sets the dead interval value to the default value of 40 seconds.

Syntax

ip ospf dead-interval seconds no ip ospf dead-interval

20-18 IPv4 Routing Protocol Configuration