Enterasys Networks 9034313-07 manual Show eapol, Switch command, read‐only

show eapol

This example shows how to reset the 802.1X quiet period to 60 seconds on ports ge.1.1‐3:

C3(su)->clear dot1x auth-config quietperiod ge.1.1-3

show eapol

Use this command to display EAPOL status or settings for one or more ports.

Syntax

show eapol [port-string]

Parameters

port‐string	(Optional) Displays EAPOL status for specific port(s). For a detailed
	description of possible port‐string values, refer to “Port String Syntax Used
	in the CLI” on page 7‐1.

Defaults

If port‐string is not specified, only EAPOL enable status will be displayed.

Mode

Switch command, read‐only.

Example

This example shows how to display EAPOL status for ports ge.1.1‐3:

C3(su)->show eapol ge.1.1-3

EAPOL is disabled.

Port	Authentication State	Authentication Mode
--------	--------------------	--------------------
ge.1.1	Initialize	Auto
ge.1.2	Initialize	Auto
ge.1.3	Initialize	Auto

Table 26‐2 provides an explanation of the command output. For details on using the set eapol command to enable the protocol and assign an authentication mode, refer to “set eapol” on page 26‐23.

SecureStack C3 Configuration Guide 26-21